|
|
Post by dave632 on Apr 30, 2017 17:28:05 GMT -7
I have used paper clips in the past and it works in a pinch but for the best results I use solid brass rod, .032 in diameter bent into a V shape. I use a small drill bit, a little smaller than the brass rod, .029-.030 so the bar is a press fit and I install it right into the chassis. You can add a touch of glue if you like but in most cases I use none. Simple and it works.  Wheelie bar 2
 Wheelie bar 1
|
|
|
|
Post by bluesguy on Apr 30, 2017 21:35:18 GMT -7
Thanks man, for sharing that.
The fastest pancake builder, #1 on the list is so generous when it comes to helping everyone get faster.
You da man Dave
|
|
|
|
Post by dave632 on May 1, 2017 11:27:04 GMT -7
You are welcome, hopefully this will help.
|
|
|
|
Post by GTS on Feb 1, 2018 8:41:39 GMT -7
Can you suggest a comfortable height for the rear of the wheelie bar to be off the track?
|
|
|
|
Post by dave632 on Feb 1, 2018 13:46:43 GMT -7
I use a simple method there to. I just leave enough for a fingernail to get between the wheelie bar and the track. If you leave to much the bar can jerk the car right out of the groove when it hits the track. When I ran full size I actually had the bars lift the rear wheels off the track. I had the 4 link set to aggressively in that case also.
|
|
|
|
Post by GTS on Feb 1, 2018 14:12:01 GMT -7
Thanks a bunch, Dave! Appreciate the tip  |
|
|
|
Post by dave632 on Feb 1, 2018 22:24:37 GMT -7
Glad to be able to help.
|
|
