|
|
Post by nosubfor3 on Oct 22, 2016 10:36:06 GMT -7
Dave what chassis are under your KOT body's?
|
|
|
|
Post by dave632 on Oct 22, 2016 12:48:42 GMT -7
All BSRT G3s.
|
|
|
|
Post by dave632 on Oct 23, 2016 6:58:18 GMT -7
Check the earlier post with a further description of the rest of the chassis. All BSRT parts.
|
|
|
|
Post by ecbill on Oct 29, 2016 16:03:01 GMT -7
What's the difference between Pro Street Outlaw and Pro Stock Outlaw? Which is one are the initials PSO referring to?
|
|
|
|
Post by dave632 on Oct 29, 2016 16:31:17 GMT -7
Bill, it should read Pro Street Outlaw. Pro Stock Outlaw was put in by mistake in the earlier post.
Here are the rules once again:
AFX magna-traction and non magna-traction cars 3 or 4 gear with up to 2 traction magnets, Any factory arm
including mean green etc. 5.5 ohm minimum, any wheel tire combo, any ceramic motor mags including dash, wheelie bars, braid and shunts allowed.
Hard plastic or resin bodies only.
|
|
|
|
Post by ecbill on Oct 29, 2016 17:07:33 GMT -7
They seem to interchange the words street and stock in this weekends events too.
So at your event , there will be both a field of Pro Street Outlaws and a list race of Pro Street Outlaws.
One of the coolest things about your races is that you don't get too nit picky about the rules.
|
|
|
|
Post by dave632 on Oct 29, 2016 17:32:18 GMT -7
Yes, I think we have all transposed Street with Stock.
Yes Bill, I am holding both list races and a class of Pro Street cars so one car can do double duty if you wish. We are planning on adding Inline stock to by race Monday.
I personally hate nit picky rules that have NO effect on performance. When that starts to happen I will avoid those races. The latest race rules here all seem to have been written with common sense and common sense is not so common.
|
|
|
|
Post by SKR on Oct 30, 2016 3:09:37 GMT -7
it is Street. I'm so use to saying Pro Stock that I sometimes type it instead of Street. I went back and edited a few posts from this weekend and apologize if there was any confusion.
|
|
|
|
Post by SKR on Oct 31, 2016 8:25:39 GMT -7
Inline Stock has now been added to the line up. Sign up now.
Inline Stock Any stock production Inline 6 ohm or higher chassis, no specialty chassis, BSRT/Wizzard,Viper etc. any slip on tire or wheel, wheelie bars allowed. Hard plastic or resin bodies only. Any gears allowed.
|
|
|
|
Post by nosubfor3 on Oct 31, 2016 11:04:56 GMT -7
Inline Stock has now been added to the line up. Sign up now.
Inline Stock Any stock production Inline 6 ohm or higher chassis, no specialty chassis, BSRT/Wizzard,Viper etc. any slip on tire or wheel, wheelie bars allowed. Hard plastic or resin bodies only.
For those who wish to run Super G+ chassis. Keep in mind the STOCK rear axles have a center flange which only accepts stock rubber tires or GEL CLAWS makes a pair of replacement tires. If the rubber tires are trued you can get some awesome traction. Other than that if the rules allow you need to sand the center and outer flange's off to apply regular silicon tires. Al Pinks last race touched on this in his post. On a side note JJ had a stock inline class at his last hosting which allowed sily foams. Not trying to stir the pot just some useful information. I'm good with either dissension. |
|
|
|
Post by nosubfor3 on Oct 31, 2016 11:22:24 GMT -7
AFX Pro Street Outlaw. AFX magna-traction and non magna-traction cars 3 or 4 gear with up to 2 traction magnets, Any factory arm including mean green etc. 5.5 ohm minimum, any wheel tire combo, any ceramic motor mags including dash, braid and shunts allowed. Hard plastic or resin bodies only. If I am reading the class rules correctly. We can use the Pro Street Out Law chassis and the door slammer chassis for the rules listed above. Yes? If this is so what chassis will be run for the call outs? Or is this two separate races? Looks like I can run my three gear chassis against my four gear chassis. Do I run Blue Silk or the 57 four the call out? Sorry for all the questions but at my age its hard to figure out what end of a pencil you use to write with. Ah. So you laugh. Here is my pencil.  |
|
|
|
Post by ecbill on Oct 31, 2016 13:46:12 GMT -7
Dave,
Now that its open please put me down for one car in In line stock. Maybe I'll get to be in 1st place for a little while.
I'll also plan on competing for the opportunity to race #5 on the PSO list.
Bill
|
|
|
|
Post by dave632 on Oct 31, 2016 14:04:37 GMT -7
Nosub.
They are 2 separate races.
For MY race, which includes a separate class for PSO cars beside the list challenge, it is OK to run 3 or 4 gear cars even T jets in the class racing.
It is NOT OK for the list race which is just for 3 gear AFX style cars.
Good show ECBill. I know of 2 other cars that are planning to run in the list races which should bring the total up to 9. I see some list action in the future.
Bill I have sent your request in to Sam for the #1 spot. You did well in the last race I held winning the AFX stock race if my memory is right.
|
|
|
|
Post by dave632 on Oct 31, 2016 14:11:30 GMT -7
Sam, ECBill would like the #1 spot in Inline stock if it is still available.
I would also like to add that gear changes are allowed.
|
|
|
|
Post by SKR on Oct 31, 2016 15:41:45 GMT -7
Bill is on the list and I updated the rules for the gears.
Nosub, the rules say any slip on tire or wheel.
|
|
