|
|
Post by slotcar58 on Jun 15, 2011 6:49:03 GMT -7
I purchased a couple of Dash 55 Chevy Bodies to make drag cars. When they arrived, I found that the bodies were rubbing the rear wheel wells on may smallest pairs of silicon tires. If I go with smaller tires I'll be dragging the track. Is there any alternative except trimming the wheel wells. I suspect I am not the only one who has experienced this problem. Thanks in advance for your help.
|
|
|
|
Post by 440gtx on Jun 15, 2011 13:24:36 GMT -7
I purchased a couple of Dash 55 Chevy Bodies to make drag cars. When they arrived, I found that the bodies were rubbing the rear wheel wells on may smallest pairs of silicon tires. If I go with smaller tires I'll be dragging the track. Is there any alternative except trimming the wheel wells. I suspect I am not the only one who has experienced this problem. Thanks in advance for your help. Are your '55 bodies for t-jets or AFX? |
|
|
|
Post by slotcar58 on Jun 15, 2011 18:18:45 GMT -7
They are for AFX and I have tried the bodies on Magnatration as well as the original G-Plus chassis.
|
|
|
|
Post by 440gtx on Jun 15, 2011 20:25:43 GMT -7
|
|
|
|
Post by pceng on Jun 16, 2011 17:22:23 GMT -7
Have two 55's from dash one for A/FX and one for t-jet. The one for the A/FX goes on chassis and clears tires with stock A/FX wheels. But you have to be real carefull putting body on. Sometimes have to wiggle it alittle to get it to snap in otherwise tires rub. The one for the t-jet sanded inside to get clearence for narrowed rear, but was so close it made me uncomfortable and ended up opening up wells slightly.
............hope this helps, PC
|
|
