kar2nr
Pro Stock
Future home of Buckeye Dragstrip
Posts: 109
|
Post by kar2nr on May 19, 2013 8:57:57 GMT -7
ProMod pancake 4gear can go as low as 5 ohms correct... and can I use EagleRacings arms for MM/PS?
|
|
|
|
Post by Phantom B.S.E. on May 19, 2013 9:08:22 GMT -7
I believe ProMod 4gear can be any stock Aurora arm no lower than 5 OHMs with ceramic motor mags.(mean green,tuff ones,or blue drag arm)MM/PS says no custom wind arms and no lower than 2.5 OHM with ceramic motor mags. That's what the rules say but I think it's time for a updated post of all class rules.
|
|
|
|
Post by AJR on May 19, 2013 9:57:06 GMT -7
All current rules are located in the Directory at the top of the page next to the Archives.
|
|
|
|
Post by pceng on May 19, 2013 10:58:29 GMT -7
Hey guys, best to check specific rules like JJ, said. Pro-Mod in 4g's is just a body style that can be used for the Doorslamer class. Either Pro-Mod or Pro-Stock type bodies can be used. The 5ohm motor is not a stock arm. Mean greens, Tuff one's, and blue drag arms are the arms referred to. Usually these arms measure over 5 ohms, in the sixes, the blue arm I think like seven ohms. Occasionally one of these arms might measure in the 5's like 5.8. The 5 ohm min. is meant to not exclude one of these arms.
The MM/PS I believe is a 2.6 min. Also for the same reason to not exclude a slightly lower arm. Think the arms have to be factory wound, no custom winds allowed.
I have been wrong before check the rules that JJ, pointed out to be sure.
...................hope this helps, Peter
|
|
|
|
Post by Phantom B.S.E. on May 19, 2013 11:44:41 GMT -7
When I said stock Aurora arm meaning made by Aurora and found in many of the different cars Aurora made,Tjets,AFX,and Aurora 4gear chassis.
THE ONLY CLASS ON THE DIRERTORY PAGE THAT LETS US USE CUSTOM WOUND ARMS IS F.E.D.
|
|
