|
|
Post by SKR on Sept 27, 2008 7:49:47 GMT -7
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on May 12, 2009 11:44:41 GMT -7
Sam,
How can you add a On off switch to this??
Joe
|
|
|
|
Post by SKR on May 12, 2009 15:02:14 GMT -7
|
|
|
|
Post by sst1610 on Jul 24, 2010 14:11:02 GMT -7
How would the wiring go for 2 power supplies?
|
|
|
|
Post by sst1610 on Nov 9, 2010 9:26:26 GMT -7
Anyone have a diagram showing the wiring for a single power supply?
|
|
|
|
Post by mobydidit on Nov 9, 2010 11:42:02 GMT -7
just substitute the power supply in place of the batteries in the above diagram. If you are using 2 supplies (1 per lane) run the negative from the supplies to the right rail in its lane & the positive to the controller & the controller to the left rail in that lane
|
|
|
|
Post by sst1610 on Nov 13, 2010 11:23:28 GMT -7
Thanks! what type of hardware do you like to use for the drivers station posts, where the controllers hook to?
|
|
|
|
Post by SKR on Nov 14, 2010 6:36:50 GMT -7
Dave, We're using steel bolts about 1/4" in diameter that are mounted to a 2x4. Track wires hook up underneath and the controllers hook up above.
Sam
|
|
|
|
Post by sst1610 on Nov 14, 2010 6:59:31 GMT -7
Great, thanks Sam
Dave
|
|
|
|
Post by SKR on Nov 14, 2010 7:01:55 GMT -7
No problem. Sent you a message
|
|
|
|
Post by Joe65SkylarkGS on Jan 21, 2011 19:45:15 GMT -7
How about if i'm using Tomy Track? Just until I can get a real Strip.
I have 2 tapped tracks i'd like to add to get better power down the entire 20 plus feet?? How do I wire these 2 in?? ANd where??
|
|
|
|
Post by SKR on Jan 26, 2011 18:20:55 GMT -7
Hey Joe, Are you using terminal tracks for the taps or are you wiring straight to the rail? Any case you'll have to run wire just like the above diagram. Negative to the rail and positive through the controller hook up or vise a versa depending on which direction you run your track. If your running two power taps I'd place one at the start and one at mid tack. Hope this helps.
Sam
|
|
