|
|
Post by SKR on Nov 27, 2008 11:19:12 GMT -7
I have another MM/PS going on auction tonight at 6pm PST. This car will be sold as a kit that will include all the hop up parts needed to have a competitive racer. Motor assembly tool is also included. I did install the crown gear and rear wheels already. Display wheels with axle and Race wheels on a separate axle with gear are included. Check it out if your interested shop.ebay.com/merchant/skrcustomsDisplay rear wheels/tires  Racing rear wheels and tires are Wizzard silicone foams .448"    |
|
|
|
Post by SKR on Dec 4, 2008 15:46:39 GMT -7
Last MM/PS I'm putting on ebay this year. It's a replica of Lee Shepherd's early eighties Camaro. Same goodies included with this car as the Mustang has. On ebay tonight. shop.ebay.com/merchant/skrcustoms  |
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Dec 4, 2008 16:54:17 GMT -7
Last MM/PS I'm putting on ebay this year. It's a replica of Lee Shepherd's early eighties Camaro. Same goodies included with this car as the Mustang has. On ebay tonight. shop.ebay.com/merchant/skrcustomsWhere do you get these wheels? Okay...if it's a State secret I understand |
|
|
|
Post by sst1610 on Dec 4, 2008 16:59:06 GMT -7
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Dec 4, 2008 17:08:34 GMT -7
Oaky...so they are for show? They show well! |
|
|
|
Post by SKR on Dec 4, 2008 17:34:17 GMT -7
They are Vincent wheels. They do show nice! The reason I include these is it gives the owner the option of sanding them down and making wheel inserts for the delrin wheels. They look nice but unless your going to add foam tires and silicone them yourself then your going to have to run slip ons tires which are not as good as silly foams.
Sam
|
|
|
|
Post by da big ragu on Dec 4, 2008 19:46:34 GMT -7
 now that is a bad bi----ch yeah i like i like sam you need to do some more chevy's for shure
|
|
|
|
Post by gm454 on Dec 4, 2008 23:04:05 GMT -7
Ragu,
I just finished the rear wing for one of those camaro pro stock bodies to fit the tjet chassis. With that wide body and a tjet chassis, you should be able to run a steam-roller setup on the rear wheels/tires and still put the body in the weeds. All I have left to do is make a mold for the wing and 'chute and a couple of decal packages and they will be ready to go. Hope to get the wing and 'chute molds done tomorrow (after I finish the paint and details on a new '51 chevy gasser)
(sorry for hijacking your thread Sam.)
Back to the original thread here. Great looking 3rd gen Camaro Sam. Is the blue pin stripe done in paint, decals or really thin pin striping tape?
|
|
|
|
Post by SKR on Dec 6, 2008 20:13:29 GMT -7
Hi Gary, The blue pin strip is part of the decal kit. I don't have steady enough hands to do striping like that. Your Camaro kit is looking good. I'm looking forward to seeing a finished one with decals.
|
|
